Here is a kit with a slide-in mount for Kahe POD and PVC glue. This kit allows you to glue a Kahe POD mount to boats that do not have a slide-in fin box or US box. For example, on tenders or inflatable float tubes. Gluing is very simple: simply mark the location of the mount, sand it lightly with sandpaper, apply glue to the mount, and then apply it to the boat. It sets quickly, but you must wait 24 hours before use. Everything is non-removable after that.

1) Mark the location of the interface

(on a kayak, you can position it so that the front of the Kahe POD is approximately in the center of the kayak, so the support is slightly set back by approximately 30 cm from the center of the kayak):

2) Lightly sand the PVC of the boat with sandpaper at the level where the support will be glued

3) Also sand the underside of the support

4) Apply PVC glue to the underside of the support

Apply the adhesive to the entire surface that will be in contact with the boat, then press the adhesive onto the boat. Press firmly until it begins to stick. Then leave it in place for 24 hours to allow the solvents to evaporate.